DRV8302: always fault happen

Part Number:DRV8302

Hi all:

I am using DRV8302 for motor driver.

Our PCB circuit design is follow DRV8301 EVM. But We always get Fault pin feedback .

we already check all function include :

--Buck part design (24V to 3.3V design follow BOOSTXL-DRV8301)

--GVDD cap.

-- Bootstrap cap.

-- charge pump cap.

-- bulid-in OPA setting

--PWM mode,OC mode, OC_ADJ, DC_CAL setting.

When we Pull EN_GATE signal as High state , the Fault pin is active(drive low).

is there any layout issue or some detail we miss?

here is our layout  and  the DRV8302 PCB circuit as attachment.

Thanks

Andrew

Top  + Bottom view

bottom view

(Please visit the site to view this file)