Part Number:DRV8332
Hello,
i wont to use Three-Phase Motor Driver to drive 3 LED (Vled = 15V, ILed=1.5Amax )
LED will be maximum driven to 800mA.
Every LED channel must me independently controlled, that is the reason for not using serial control interface.
Requirement for circuit is to use Current set pin to limit the current on channels, like OC_ADJ pin on DRV8832, but bad side of this IC is temp range +85C.
can you confirm me that in worst case of temperature rise to +95C this IC will withstand and work?
If DRV8832 can not withstand +95C, can i regulate current on DRV8313 in the same way, or there is some similair IC in temp range +125C?
looking forward to you fast reply.