Team,
Can you please help with the below?
According to datasheet page 27 section 7.3.7 the input ("SPEED/WAKE") of the component can be programmed accordingly (analogue, PWM, frequency and I2C):
https://www.ti.com/document-viewer/MCT8329A/datasheet#GUID-CE69478D-12C1-4293-8C5A-960578FDF846/TITLE-SLVSEX6T5566057-12
The questions I still have are (page 27 in the data sheet / term: "SPD_CTRL_MODE"):
- Is there a default pre-configuration for the input (e.g. "analogue in") that the controller/driver is in at the factory, or does that need to be configured before use?
- Is the configuration reset after a restart and does it always have to be reconfigured, or does the controller retain the configuration?
- If the configuration is retained, is it possible to get a pre-configured component from TI directly?
Or are distributors (like Arrow) or some TI partners proposing this service?
Can you please point to some collaterals that are related to EEPROM programming (ie procedure, tools, ..etc)?
The two modes of interest are preferably analogue and as a second choice PWM.
Thanks in advance,
Anber
.jpeg)
