We try to drive motor in the -10C temps chamber
Whenever the motor fails to start during the test and the EVM BD Fault LED lights up
I will power off for 5~10 minutes and wait for the LED to turn off before continuing to the next round
but at the end I see a current exceeding the limit of 8A (please Refer to the picture below)
After,I couldn't start it anymore, so I tried using the GUI tool "Control fault setting", but it still couldn't be started.
I have disabled HW_LOCK_limit_mode, but it still doesn’t work.
Maybe that's why it is broken…
Is there other ways to confirm this EVM BD is still normal?
