Not having much luck using the GUI. I'm using version 1.0.1. Two major issues:
On one device, I am only able to launch the GUI via the installer. Once I close it, it is not possible to reopen, even with a restart. It can only then be opened again via reinstalling.
Worth noting that when running, it does work correctly for a time. I can read from the registers successfully, however I do have periodic connectivity issues which it suggests should be solved with a restart...
I have since installed again on a second device. This installation is able to close and reopen fine. The connection status bottom left shows as Hardware Connected, but as soon as I try to read from the registers or interact with the board in any way, I get the following error:
a restart does not solve the issue.
Running out of ideas here, would be great if someone could provide some help in solving the issue on one/both devices.
