Hi,
MPET motor parameter estimation sometimes succeeds, but why is it overwhelmingly unsuccessful?
Is there a way to reset when parameter estimation fails? (I want it back to MOTOR_IDLE)
After turning on the power, whenever I try to operate the motor, it always goes into parameter estimation mode. Is there a way to avoid this?
I want to write the estimated value and start it immediately after turning on the power.
I want the parameters to be adjusted that are considered necessary to be reflected in the motor speed as soon as possible when starting or changing the speed.
Even if the motor does not rotate (the load is large), is it possible to operate at the very limit of the rated current?
For braking action, is it possible to keep the motor electrically held in a certain position?
Thanks,
Conor
