we connect the EN/EN1 DIS/EN2 together in PCBA. we use three DRV3946QPWPRQ1 in one PCBA.
the others two can try the EN/EN1 DIS/EN2 low to disable the LSD output.
but one chip's EN/EN1 DIS/EN2 (below orange) try low can't disable LSD output (below green), until its power (red) is low.
I try other PCBA, same issues. After check with SW, they said they should be same configure.
from datasheet to understand, when EN/EN1 DIS/EN2 is low, the LSD will disable output mandatory, not relative to register configure or others.
is there any register to set the EN/EN1 DIS/EN2 out-of-control the LSD output when they are low? or is there anything issue else?
