Hi team,
Here're few issues from the customer may need your help:
Customer uses MCT8329A to design the driver and plans to use speed control, speed/wake pin input voltage to adjust speed.
1) The analogue voltage amplitude entered corresponds to duty CMD and VANA_FS corresponds to 100%. But how to set Vana_FS to the recommended value of 3V? Is the default value 3V and cannot be changed?
2) Duty CMD*MAX_SPEED gets the speed command value, is this MAX_speed an electrical or mechanical frequency? How are the pole pairs of the motor considered and set?
3) As per the following register configuration, is MAX_speed configured to 16000/16 = 1000Hz?
4) Is there a routine available to write to the EEPROM of the MCT8329A?
Could you help check this case? Thanks.
Best Regards,
Cherry
