The DRV2605LEVM-MD board had been working. I was using the board with 8 LRA motors for up to two hours continuous operation. All work was done wiith external power (5v/2A).
When trying to reconnect, the haptic console recognized the board, but after clicking connect (the globe icon in the top line to the right, the software become non-rsponsive, and had to be shut down. At that time, the board LEDs flashed as expect when connected to external power, and linking to the GUI when pressing switch 1.
I tried re-updating firmware. I got to the point saying update started, and it did not progress to complete the install. Now when connecting the board to power, the top left green LED lights, but when connecting to the USB port, B1/B2 barely flash and LED1 does not light. SW1 appears to have no effect.
Suggestions?
