Difference between R12 and R13 labels on the DRV8312EVM RevD and the schematic provided in controlsuite

Good Day,

I recently bought a DRV8312-c2-kit and i was looking at the VDCBUS connection to the adc-b2 pin. Connected to the VDCBUS line is a connection from PVDD through a voltage divider created by R12 and R13. When comparing the positions of  the 2 resistors with the schematic provided in controlsuite"DRV8312EVM_RevD_Schematic" the positions of the 2 resistors are interchanged. I proceeded to perform a continuity test on the board and this showed that R12 is connected to GND and R13 is connected to PVDD. Again the schematic says the opposite. Can someone please inform me of what the correct arrangement is and what the resistor values are supposed to be for each of the resistors.