DRV8305-Q1EVM: How to control with hall sensor

DRV8305-Q1EVM is basically sensorless control, but I would like to use with hall sensor.

I just connect as below, but the operation is same as sensorless.

I'm using InstaSPIN GUI and, software setting is same as User's guide.

Would you teach me how to use with sensor ?  Thanks.

- Jumper J8 : connect to 5V

- Connect motor's hall sensor and H13 as below. 

 Motor sensor               EVM  H13

 VDD(5V)            -       pin 5

 U                       -        pin 4  

 V                        -        pin 3

 W                       -        pin 2

 GND                  -        pin 1