DRV3245Q-Q1: how to stop motor operation?

Hello.

i'm using DRV3245Q-Q1 device and i input IHx, INx based on Datasheet's Truthtable.

when i set all IHx, ILx as Low(0), truth table says GHx, GLx should be set as Low output.

but when i set IHx, INx as low(zero)value, GHx is set High, GLx is set Low. so 3phase output set as High(because Vdrain is 14V, out value is about 14V)

i asked this question already, but TI person deleted it and there is no reponse from TI person.

pleaes don't remove this article or if TI person delete this article, please give me a proper response.

thank you.