DRV8328AEVM: DRV8328AEVM

the following defaults should appear when the GUI is connected:

• Direction – Enabled

• PWM Frequency (Hz) – 20000

• MCU Dead Time (ns) – 0

• Acceleration Delay (ms/1% duty cycle) – 21

In soite of Clicking  on the “Output Enable” switch,

the phase A,B,C voltage level is so high( about 7V)  and does not toggle, 

That means INHA(B,C),INLA(B,C) signals are not toggle and motor does not rotate yet.

I need help how to make the motor work normally.