MCT8316AEVM: Regarding GUI issue

Hi support team.

 I had a question regarding GUI from my customer.

We followed the setup steps shown in the GUI and found that when I clicked the settings button shown in the figure below, Fault was detected and the motor could not be controlled.

I could control the motor without any problem without clicking the button.

I compared the register settings before and after clicking the button, I confirmed the change in the register settings like the attached Excel file.

Why are these changes made?

Especially because the register setting that is "RESEVE" has changed.

We suspect it's a GUI errata.

Best regards,

Higa

e2e.ti.com/.../MCT8316A-GUI-analysis.xlsx