DRV8308 sequence start running

Hi everyone,

Im  working with the driver DRV8308 but so far i didnt achieved to make it works.

I have doubts about the sequence or steps i must follow to do so.

First of all, let me show you my registers table

Well, so far im able to write these registers and to read them so i can check they are correctly written.

Once this is done it is suppossed that the ENABLE pin is active already, because the ENPOL bit is = 1 (ENABLE active with low level) and the GPIO is low.

But i cant see the motor working.

My ask is ¿what is the correct sequence so the motor starts moving?

Thanks and best reagrds