DRV8308EVM no communication between Gui and MSP430.

Good day,

I wanted to do some testing with the DRV8308EVM, but the GUI will not load without installing Gui composer.

And when GUI composer is installed it the GUI see's the USB to Uart chip from FTDI but it will not show the used processor.

After this point its clear that there is no communication between DRV8308EVM and the GUI. 

We made a interface the board with a MSP-FET programmer to program the MSP. We programmed with the firmware delivered with the GUIv1.2 file but no luck.

Did we miss a library for Uart communication?? Also tried to make it work with Linux but faild to launch GUI composer after install...

Vincent Brakshoofden