Part Number: BOOSTXL-DRV8305EVM
Tool/software: Code Composer Studio
I have changed all the parameters to match my motors, as established using the motorware GUI. The GUI runs one motor just fine, so I know the hardware is capable, but when I try to run them using lab 11d I get the fault light come on. I don't know what I am doing wrong.
I am using the F28069M launchpad with DRV8305 BoostXL boards.
The motor I am using is Quanum MT Series 5208 360KV Brushless Multirotor Motor Built by DYS
Specs:
KV(RPM/V): 360KV
Lipo cells: 4-6S
Max Power: 674.9W
Max Amps: 30.4A
No Load Current: 0.70/22.2V
Internal Resistance: 0.45ohm
Number of Poles: 14
Dimensions(Dia.xL): 63*27.7mm
Motor Shaft: 4mm
prop shaft: 6mm CW prop adapter
Weight: 192g
bolt hole spacing: 25*32*44 M3
Lamination thickness: 0.2mm
Magnets: 42SH
Wire: 18AWG
Connector: 3.5mm bullet
