DRV8711: DRV8711DCPR

Part Number:DRV8711

Hi , 

We would like to use below TI motor driver part in our existing design. part is as below

DRV8711DCPR

In existing design  we have used controller which does not have SPI interface. 

If we need to interface with our exiting micro controller is it possible to use it in parallel or IO mode? as current controller doe not support SPI interface.
Alternately can you pl. suggest any chip for this ? so that we can use motor driver in IO mode. We need at least 128 micro steps. 

Pl. revert at urgent. 

Thanks in advance.

Regards,
Amod