Part Number:DRV8432
Hi everyone.
I would like to have some information about the overcurrent limit of FULL BRIDGE MODE OPERATION (figure 8 of the data-sheet), in which two DC motors are connected to the driver. In particular, I would like to know whether the OC-ADJUST RESISTOR is referred to the over-current value of EACH motor, or to the total amount of the current provided by the driver. For example, I want to set an overcurrent value of 4.1 A for EACH motor. In this case, is the OC-ADJUST RESISTOR of 68 kOhm (shown in the data-sheet) correct?
Thank you in advance
Francesco
