Part Number:DRV8829EVM
Hi team.
I want to know how to use on GUI.
I have some questions.
1. Regarding the switch S1.
How to set S1 when I want to use MCU and GUI(Application for DRV8829 EVM)?
My understanding is S1-7:High and S1-8:Low.
Serial mode is always need Low?
2. Regarding when I set the switch S1 is S1-7:High and S1-8:Low.
2-1 : When all check boxes were cleared in the Control Signals, the motor moved when the start steps button was pressed the in Stepper Control Screen.
Is this normal work?
2-2 : When Enable check box were checked in the Control Signals, a current of about 4.5 A flowed to the Vout terminal.
Why does the current flow? Is this normal work?
2-3 : Can I control a current flow in the Control Signals screen?
3.When I want to use my MCU, how to connect this EVM?
Sincerely.
Kengo.
