Part Number:DRV10983Q1EVM
I'm trying to setup the motor parameters for a BLDC pump.
The phase to center tap resistance is measured at 0.5875 Ohms (half of the phase-to-phase resistance).
Looking at the datasheet (table 3), the nearest value would be 0x2F (0.582 Ohms)
But when I try to enter 0.5875 into the GUI, the number automatically jumps to "1" ohms. (this is true for any number less than 1)
The only valid numbers for phase to center tap resistance are full integers between [1..18], except 10 and 15..
How can I setup the board to use 0x2F / 0.528Ohms using the GUI?
Or is there another way I can force the board to use 0x2F as value?
