Part Number:DRV2511-Q1
Hello team,
is it possible to use this driver in half-bridge mode? This could save money on discrete components.
Configuration could look such as this schematic. Connecting actuator on OUT+ and leave OUT- unconnected.
This means IN- would be VCC3/2 and IN+ will be driven with a variable voltage from 0..VCC3.
Is this a possible configuration?
What would be the maximum duty cycle? Is a 100% (or 0%) duty cycle possible with DRV2511?
Is open connection of OUT- possible? Any protection or diagnostic issues?
This all would save additional discrete components such as cap, filter and snubber.
Many Thanks
Josef
