shunt-resistor in each phase in( Directly measurement on the phase line ).

hi every one!

I am using motorware18  prog_lab3a (for ACIM).

as you may know in most of IGBT packs we do not access to leg of each low-side IGBTs .(like 7MBR50SB120)

I want to use Directly measurement on the phase line rather than Measurement on the low side of the half-bridge I am going to use ACS758LCB-050B as Measurement sensor .

my questions:

1. what change should be made in CCS code?

2.do you think this sensor (ACS758LCB-050B) is suitable for current measurement,(Please explain about it)

thanks for attention

Regards.

Dave.