Part Number:DRV8703-Q1
Hai,
We have three mode of operations in the DRV8703-Q1. For mode selection we have to configure the MODE pin.
0 ( Connecting to the ground GND ) - PH or EN ( Mode 1 )
1 ( Connecting to the +Vcc ) - Independent half-bridge ( Mode 2)
These are for first 2 modes.
But I want to operate my driver IC in mode 3 ( Standard PWM ), for that MODE pin should be provided with HiZ ( High Impudence ).
So, how to put that pin to high impudence while it was connected to the external micro ?