DRV8262EVM: DRV8262EVM

Tool/software:

Hello, 

I received DRV8262EVM (DDW) package and successfully installed TI Cloud based GUI. 

I am trying to use single H-bridge for a brushed DC motor with PWM interface instead of PH/EN. 

According to its manual, it seems that GUI only allows me to stop the motor when both IN1 and IN2 is set to 0 (coast mode)

Is there anyway that I can configure IN1 and IN2 to 1 so I can try to use its brake function instead of coasting? Ultimately, I want to see which one would be faster to stop the motor when using an external brake as part of the motor module. I don't see register configuration available for DRV8262 setup. Also, is there a way to disable the bus voltage (VM) with GUI? 

Thanks