DRV3901-Q1EVM: About output confirmation

Tool/software:

Hello TI

Let me ask you two questions.

・I would like some help as I cannot confirm the output of the evaluation board. 
　The deployment settings are set to TRG1 and 2 pins Hi. 12V is applied to VSUP. 1.5V or more is applied to TRG pins 1 and 2.
　 I shorted OUTH and OUTL and measured the current with a current probe, but no current flows. What should I do?


・I was able to confirm that current flows when I click the 'perform SPI Deploy' button.
　When I measured it, it was 2.0A/0.6ms compared to the setting of 1.75A/2ms. Is this difference within the margin of error? 　
　Also, when I set it to another current value, it reverts to the default 1.75A/2ms. What should I do about this?

Thank　you