ULC1001-DRV2911EVM: Configuration file loading in on-board MSP430 MCU

Tool/software:

Hi TI Experts,

Let's say, I am changing the user parameters in GUI for specific LCS and saving those configuration file without doing calibration in GUI. Then I load the un-calibrated configuration file in the MSP430 through MSP-FET tool and executing calibration mode through MCU by pushing the run calibration button.( Reason for calibration through MSP430 is we are planning to use similar approach in end product to calibrate every ULC1001 device with its assembled LCS to adopt with the manufacturing variations on LCS)

Q1: Does the post calibration burst parameters are updated in the MCU configuration file? If I power cycled the EVM, does the ULC1001 boot up with the updated calibration file or previous loaded file?

Q2: Where does the configuration files are stored and how it's parameters are updated after calibration?

Q3: Why EEPROM is used in this EVM?

Best regards,

Selvaganapathi K