MCF8316AEVM: Assistance Needed – MCF8316AEVM Not Running BLDC Motor

Tool/software:

Dear TI Expert,

I am trying to run the MCF8316AEVM with my BLDC motor but have not been successful. I have set the switches and jumpers according to the guide, but the motor does not run. I also attempted to control it using the GUI application, but without success.

After watching a TI video on the MCF8316A, I noticed that in my setup, the VM voltage remains at zero. However, when measuring VBAT to GND on the MCF8316AEVM, I receive 20V.

It is important to note that I have tested three different working BLDC motors and also switched from VBAT to VM. Additionally, I restored the default values and successfully read all 32 registers.

What could be preventing the motor from running?

Setup:

stay 0.028A even when I roll CCW the pos.


 

I would appreciate any guidance you can provide.

Thank you!