DRV2510-Q1: Minimum load impedance

Tool/software:

Hello,

we have an application that the DRV2510-Q1 is perfect for; however, I noticed the minimum load impedance under recommended operating conditions is listed as 1.5 Ohms. Can you please explain what happens if our load impedance is 0.75 Ohms? Also, if we were to implement the optional LC filter shown in figure 8-1 of the data sheet, and if we were to operate the DRV2510 off 8V while dumping the current after the LC filter into a 0.75 Ohm load does that help (since the DR2510 will operate similarly to a buck converter, I believe).

Thanks