DRV2605L-Q1: Analog input in self-defined frame sequence /PWM 100 %

Tool/software:

Hi,

My costumer is using alert signal with 750ms - and Alert 100%  (wafeform  id. 15). During this waveform the PWM is only 78% and they wanted to know if it is possible to set this PWM to 100% ?

Or is it possible to set the PWM to analog during a self-defined frame?  In the control register I saw that we use analog input. But it is also possible during the frame sequence (e.g.  Soft start with PWM and then switch to analog input)?

 Thanks,

Oscar