When starting the DRV10983 EVM control software, I get the message "An update to the device is required. Please make sure that the power supply is greater than 22V and press OK."
I made sure that the it is greater than 22V (it's actually 24V). I made sure that this was so. My laptop is connected to the USB2ANY and it's light is on indicating such. I can only get the software to come up if I say to continue in simulation mode then continue. Subsequently, it is put into DEMO mode.
I did make sure that I saw 24V where everywhere I'm supposed to.
This software has always been buggy (both versions). Currently using v3.0.5
Need help ASAP.
L.Keel