ULC1001-DRV290XEVM: ULC1001-DRV290XEVM

Hello,

I have the ULC1001 EVM (old module) without the new updated ULC1001 chip and i am using the old FW.

I tried to run the calibration of the chip but it keeps freezing. You can notice at the bottom left the it's mentioning (read user... 0x1) and it keep alternate between that and idle text forever.

I would like to check what can be the source of the problem, how can i verify that the board is correctly read by the SW?

The PCB was working fine (the SW is uploaded and it works fine) i just wanted to test it again but that happened (i didn't change anything in the settings).

Thank you very much.