DRV8316REVM: Universal control lab using DRV8316REVM, LAUNCHXL-F280025C, BDLC motor

Hey, 

In the User’s Guide Motor Control SDK Universal Project and Lab , I'm trying to do the Build Level 1 lab with no success.
I'm using :DRV8316REVM, LAUNCHXL-F280025C

In - 2.5.1.3 Run the Code when I'm trying to set the motorVars_M1.flagEnableRunAndIdentify to 1it instantly go back to zero 

I found out that the motor motorVars_M1.motorState = MOTOR_FAULT_STOP and when measuring with oscilloscope there is no output from the phases

predefined Symbols:

In addition I will note that i read this post and it did not help. 

I would appreciate your assistance,